产品分类
联系我们
电话: 0512-668779
传真: 0512-668779
邮箱: ygxohsnvjp@eventphotoshop.com
地址: 江苏省苏州市
新闻中心

气密性检测仪如何维护

1、探头清洁:利用附送的防护罩防止灰尘、水汽、油脂阻塞探头,在使用本仪器前,均要检查探头和防护罩确无灰尘或油脂。拉下防护罩,用工业毛巾或压缩空气清洁防护罩,如果探头本身也脏,可浸入像酒精等温和清洗剂几秒钟,然后用压缩空气或工业毛巾清洁,严禁用像汽油、松节油、矿物油等溶剂,这样易降低仪器灵敏度。

the probe cleaning: use with protective cover to prevent dust, moisture, grease plug the probe, before using this equipment, are to check probe and a protective cover has dirt or grease. Pull off protective cover, for industrial use towels or compressed air clean protective cover, if the probe itself is dirty, can be immersed as alcohol isothermal and cleaning agent for a few seconds, and then use compressed air or industrial towel clean, is strictly prohibited to use as gasoline, turpentine oil, mineral oil and other solvents, so easy to reduce the sensitivity of the instrument.

2、探头更换:探头最终总要失效,需更换。由于探头寿命直接和使用条件和频次相关,因此较难预计准确的更换时间。当在清洁、纯净空气中报警或不稳定时,应更换探头,具体探头步骤是如下:确认本仪器处于关闭状态,逆时针旋下旧探头,顺时针旋上包装箱中提供的备用探头。

the probe replacement: probe the final total to failure, in need of replacement. Because the life of probe directly and the conditions of use and frequency, so it is difficult to replace the time accurate. When in clean, pure air alarm or unstable, should replace the probe, the specific steps are as follows: the probe confirmed that the apparatus is closed, clockwise rotation of old probe, Shun spare probes provide packing box on the clockwise rotation.

气密性检测设备

BACK

版权所有:江苏省汇欣氨气检测仪有限公司, All rights reserved

地址:江苏省苏州市  电话:0512-668779  邮箱: ygxohsnvjp@eventphotoshop.com